Practical explanations of Ontario Building Code, permits, and inspections
Practical explanations of Ontario Building Code, permits, and inspections
Practical explanations of common building inspection issues in Ontario, including framing, plumbing, insulation, fire separations, and final inspection failures. These articles explain what inspectors look for and why certain deficiencies prevent approval.
Wall framing relies on continuity to properly transfer loads from the roof and floors down to the foundation. One common framing deficiency observed during inspection is a top plate splice occurring between studs without proper staggering or approved tying. Although…
One of the most common framing deficiencies identified during inspection is not caused by poor workmanship, but by partial compliance. Structural framing often looks solid on site, even when key alignment or bearing requirements are not fully met. Beams that…
Deck construction in Ontario often begins with a properly installed foundation, such as helical piles or concrete footings. However, the long-term performance of the deck depends just as much on how the wood posts are connected to that foundation. A…
If your sink drain drops straight down immediately after the trap, you likely have an S-trap — and in Ontario, that is a guaranteed inspection failure. This issue is extremely common in DIY work and older renovations, and it often…
Exterior cladding must be installed with adequate clearance above finished ground to protect the wall assembly from moisture exposure, snow buildup, splash-back, and premature deterioration. One of the most common exterior deficiencies identified at final inspection occurs when siding is…
Homeowners often ask the same question near the end of a build: “The house is almost done. One or two rooms aren’t finished. Can we move in?” In Ontario, the answer is sometimes — depending on what is unfinished. The…